Router Stencil - Heart (Coaster Size(4 set))
This stencil is in the shape of a heart. It is roughly the same dimensions of an average coaster for tracing on wood and then using a router table or hand router to cut out.
Use double sided tape to apply the stencil to the work piece when you are ready to trim it.
This comes as a set of 4 stencils, all in black.
*As always, stay safe when using a router table or hand router, and use these correctly. Use a jigsaw to cut or any other tool to remove material to within 1/8 inch of material overhang from the stencil edge. Failure to do so could cause possible tear-out to your workpiece.
*Make sure your height is adjusted so the bearing is just riding on the edge of the stencil. Failure to do so could result in damage to your stencil.
**ALWAYS FEED YOUR WOOD IN THE CORRECT DIRIECTION OF YOUR ROUTER FLUSH TRIM BIT!
This stencil is in the shape of a heart. It is roughly the same dimensions of an average coaster for tracing on wood and then using a router table or hand router to cut out.
Use double sided tape to apply the stencil to the work piece when you are ready to trim it.
This comes as a set of 4 stencils, all in black.
*As always, stay safe when using a router table or hand router, and use these correctly. Use a jigsaw to cut or any other tool to remove material to within 1/8 inch of material overhang from the stencil edge. Failure to do so could cause possible tear-out to your workpiece.
*Make sure your height is adjusted so the bearing is just riding on the edge of the stencil. Failure to do so could result in damage to your stencil.
**ALWAYS FEED YOUR WOOD IN THE CORRECT DIRIECTION OF YOUR ROUTER FLUSH TRIM BIT!
This stencil is in the shape of a heart. It is roughly the same dimensions of an average coaster for tracing on wood and then using a router table or hand router to cut out.
Use double sided tape to apply the stencil to the work piece when you are ready to trim it.
This comes as a set of 4 stencils, all in black.
*As always, stay safe when using a router table or hand router, and use these correctly. Use a jigsaw to cut or any other tool to remove material to within 1/8 inch of material overhang from the stencil edge. Failure to do so could cause possible tear-out to your workpiece.
*Make sure your height is adjusted so the bearing is just riding on the edge of the stencil. Failure to do so could result in damage to your stencil.
**ALWAYS FEED YOUR WOOD IN THE CORRECT DIRIECTION OF YOUR ROUTER FLUSH TRIM BIT!